Select topics and difficulty and just practice mcqs.
User (name or email)
pick difficulty level
number of questions
Let's practice 30 mcqs on
mcqs by everyone
You need the IP address of the devices with which the router has established anadjacency.
Also, the retransmit interval and the queue counts for the adjacent routers need to be checked.
What command will display the required information
show ip eigrp topology
show ip eigrp interfaces
show ip eigrp neighbors
show ip eigrp adjacency
Which command will show you whether a DTE or a DCE cable is plugged into serial 0
show controllers s 0
sh int s0
sh int serial 0
show serial 0 controllers
Which of the following describes the creation of private networks across the Internet, enabling privacy and tunneling of non-TCP/IP protocols
What does a switch do when a frame is received on an interface and the destination hardware address is unknown or not in the filter table
Floods the network with the frame looking for the device
Drops the frame
Forwards the switch to the first available link
Which command will create a dynamic pool named Todd that will provide you with 30 global addresses
What must happen if a DHCP IP conflict occurs
The administrator must fix the conflict by hand at the DHCP server
The DHCP server will reassign new IP addresses to both computers
Proxy ARP will fix the issue
The client uses a gratuitous ARP to fix the issue
Acknowledgments, sequencing , and flow control are characteristics of which OSI layer
What is the maximum data rate for the802.
If you want to have more than one Telnet session open at the same time, what keystroke combination would you use
Ctrl+Shift+6, then X
Ctrl+Shift+X, then 6
Ctrl+X, then 6
The DoD model
(also called the TCP/IP stack) has fourlayers.
Which layer of the DoD model is equivalent to the Network layer of the OSI model
Which of the following allows a router to respond to an ARP request that is intended for a remote host
Inverse ARP (IARP)
Reverse ARP (RARP)
When a router is connected to a Frame Relay WAN link using a serial DTE interface, how is the clock rate determined
By the far end router
By the clock rate command
By the Physical layer bits stream timing
Supplied by the CSU/DSU
You need to configure a router for a Frame Relay connection to a non-Ciscorouter.
Which of the following commands will prepare the WAN interface of the router for this connection
Router (config-if) #encapsulation frame-relay q933a
Router (config - if) #encapsulation frame-relay ietf
Router (config - if) #encapsulation frame-relay ansi
Router (config - if) #encapsulation frame-relay cisco
Two connected routers are configured only with RIProuting.
What will be the result when a router receives a routing update that contains a higher-cost path to a network already in its routing table
The update will be ignored and no further action will occur
The updated information will be added to the existing routing table
How many non- overlapping channels are available with802.
Which of the following is an example of a standard IP access list
access - list standard 1 . 1 . 1 . 1
access - list 110 permit host 220.127.116.11
Which of the following descriptions about IPv6 is correct
There are 2.7 billion addresses
Broadcasts have been eliminated and replaced with multicasts
Addresses are not hierarchical and are assigned at random
An interface can only be configured with one IPv6 address
When data is encapsulated , which is the correct order
Data, segment, packet, frame, bit
Data, segment, frame, packet, bit
Data, frame, packet, segment, bit
Segment, data, packet, frame, bit
To test the IP stack on your local host, which IP address would you ping
When a station sends a transmission to the MAC address ff : ff : ff : ff : ff : ff, what type of transmission is it
Suppose you have a customer who has a central HQ and six branchoffices.
The customer anticipates adding six more branches in the nearfuture.
It whishes to implement a WAN technology that will allow the branches to economically connect to HQ and you have no free ports on the HQrouter.
which of the following would you recommend
Which of the following is part of the IEEE802.
If a host on a network has the address172.
16.45.14/30, what is the subnetwork this host belongs to
Which switching technology reduces the size of a broadcast domain
What command do you type to save the configuration stored in RAM to NVRAM
Router (config) #copy running - config startup - config
Router (config) #copy current to starting
Router#copy run start
Router #copy starting to running
Where are EIGRP successor routes stored
In the routing table and neighbor table
In the routing table and the topology table
In the neighbor table only
In the routing table only
You type Router#sh ru and receive a % ambiguous commanderror.
why did you receive this message
There is no show command that starts with ru
The command requires additional options or parameters
The command is being executed from the wrong router mode
What is the purpose of flow control
To regulate the size of each segment
To ensure that data is retransmitted if an acknowledgment is not received
To reassemble segments in the correct order at the destination device
To provide a means for the receiver to govern the amount of data sent by the sender
Which encryption type does WPA2 use
PPK via IV
AES - CCMP
What is the most common attack on a network today