Foxoyo
Hey..!!
Applied Mechanics
Practice
MCQs
Quizzes
About
Leaderboard
Amazon Books
11
MCQs
0
Attempts
0 %
Accuracy
share
Filter by
Type here
Apply
If a particle is projected inside a horizontal tunnel which is 554 cm high with a velocity of 60 m per sec, the angle of projection for maximum range, is
8°
12°.
11°
9°
10°
A projectile is fired at an angle θ to thevertical.
Its horizontal range will be maximum when θ is
45°
90°.
0°
30°
60°
The rotational velocity of a satellite is increased by 450 m per second if its launch is done from equator
westward
upward.
northward
southward
eastward
The apparent weight of a man in a moving lift is less than his real weight when it is going down with
uniform speed
retardation.
an acceleration
Linear momentum
The maximum frictional force which comes into play, when a body just begins to slide over the surface of a an other body, is known
Sliding Friction
limiting friction
None of these.
Rolling friction
One end of a light string 4 m in length is fixed to a point on a smooth wall and the other end fastened to a point on the surface of a smooth sphere of diameter 2.25 m and of weight 100 kg. The tension in the string is
22.5 kg
19.5 kg
17.5 kg
25 kg.
Ball A of mass 250 g moving on a smooth horizontal table with a velocity of 10 m/s hits an identical stationary ball B on thetable.
If the impact is perfectly elastic, the velocity of the ball B just after impact would be
10 m/sec
5 m/sec
Zero
None of these.
A satellite goes on moving along its orbit round the earth due to
None of these.
centripital force
Centrifugal force
Gravitational Force
If two forces each equal to T in magnitude act at right angles, their effect may be neutralised by a third force acting along their bisector in opposite direction whose magnitude will be
1/2 T
3 T
None of these.
2 T
For a simple pendulum, time period for a beat, is
πg/2l
π2l/g
πl/g
π2g/l.
πl/2g
ω rad/sec is the angular velocity of a crank whose radius is r. If it makes θ° with inner dead centre and obliquity of the connecting rod l is φ, the velocity v of the piston, is given by the equation
ω2(l sin φ + r cos φ tan θ)
ω2(l cos φ + r sin φ tan θ)
ω2(l sin φ - r cos θ tan φ).
ω(l sin φ + r cos φ tan θ)
1
take a quick Quiz
Practice mcqs on Applied Mechanics
Let's start
pick difficulty level
all
1
2
3
4
5
11
Mcqs
0
attempts
1
followers
Related Topics
Applied Mechanics
MongoDB Aggregation Concepts and Mechanics
MongoDB Sharding Concepts Mechanics and Cluster
Soil Mechanics And Foundation
Fluid Mechanics
Hydraulics and Fluid Mechanics
Soil Mechanics and Foundation Engineering
Engineering Mechanics
Suggested Books
Javascript is disabled
we serve best when javscript is enabled
Enable